This repository provides an ESPHome external component and a Home Assistant custom component for controlling Mitsubishi heat pumps via the CN105 serial interface. The core component implements a full climate controller with dual setpoint support, multiple operating modes (heat, cool, heat_cool, dry, fan_only), fan speeds, swing modes, remote temperature integration, and a wide array of sensors (compressor frequency, power, kWh, outside temperature, error codes, etc.). It communicates with the heat pump over UART at 2400 baud using a reverse-engineered protocol with checksum validation and cyclic request scheduling. The Home Assistant proxy component dynamically adjusts the UI to show single or dual setpoint sliders based on the active mode, fixes Auto mode behavior, and supports advanced features like coordinator single-target mode for multi-zone systems. The codebase is well-structured with standalone reusable modules for frame parsing, protocol encoding/decoding, request scheduling, and temperature conversion, supported by a comprehensive unit test suite and CI pipeline. The repository includes example configurations for various microcontrollers (ESP32, Xiao, M5Stack) and deployment scenarios, making it a mature and practical solution for integrating Mitsubishi heat pumps into smart home systems.
This repository provides ESPHome components for integrating the Xiaomi Mijia Bedside Lamp 2 with Home Assistant. It enables full control of the lamp's RGBWW LEDs, front panel touch interface (buttons and slider), and illumination through custom ESPHome components. The firmware replaces the original Xiaomi firmware to eliminate cloud dependencies and enable local-only control. The architecture follows ESPHome's component model with hardware abstraction layers (HAL) for light control and front panel I2C communication. Key features include individually controllable front panel LEDs, light presets with group support, disco mode for immediate updates, night light calibration, and smooth color transitions with hardware-aware handling of low-brightness limitations. The design emphasizes separation of concerns, with distinct modules for color handling, state management, and event processing. Notable technical implementations include a Chain of Responsibility pattern for handling different light modes (off, night, RGB, white), a flexible preset system with group-based activation, and specialized transition handling that avoids attempting smooth color changes at very low brightness levels where the hardware cannot perform them reliably. The firmware maintains compatibility with modern ESPHome versions through active maintenance and timely adaptation to API changes.
This repository provides an ESPHome component that implements a UART-to-TCP bridge, creating a serial-to-network gateway. The component listens for TCP connections on a configurable port (default 6638) and relays data bidirectionally between connected clients and a UART serial port. It handles multiple simultaneous clients using non-blocking I/O, manages a ring buffer for efficient UART-to-TCP transmission, and provides optional binary sensors for connection status and a sensor for active connection count. The implementation adapts to various ESPHome version APIs through conditional compilation and follows ESPHome's component architecture patterns.